Episode Details
Back to Episodes
Listening practice: Measuring a Small Farm Project.
Description
Measuring a Small Farm Project
Last week, I started a small project on my farm. I wanted to build a new storage area, so the first thing I did was check the measurement of the space. Then I used a tape measure to measure everything carefully.
The size of the building was important, especially the length, width, and height. The length was six meters, the width was four meters, and the height was three meters. I also checked the depth of the ground before digging.
The distance between the storage area and the house was about 50 meters. I wanted to keep the building close enough to the house but far enough away to have more space around it.
Next, I checked the weight of the materials. The area of the floor was 24 square meters, and the volume of the water tank was 500 liters. The tank had a capacity of 500 liters.
I also needed to check the thickness of the walls. The diameter of one of the pipes was five centimeters, and the circumference of a large round tank was about three meters. I wrote down every dimension before buying the materials.
For the smaller parts, I needed a millimeter measurement for some screws and a centimeter measurement for several pieces of wood. The main structure was two meters high, and the nearest hardware store was about 12 kilometers away.
Some materials were sold by weight. I bought 500 milligrams of a small chemical product for another part of the project, as well as 200 grams of glue. I also bought a five-kilogram bag of cement.
For the water system, I bought several bottles containing 500 milliliters each and two large containers holding 20 liters. I also checked the American measurements on some tools because some of them were marked in inches instead of centimeters.
One piece of wood was six feet long, and another was about three yards long. The delivery truck had to travel several miles to reach the farm. One package weighed about ten ounces, while another package weighed almost 40 pounds.
The largest machine could carry almost one ton, so I used it to move some heavy materials. For the engine, I needed to add one fluid ounce of oil. The water tank could hold 20 gallons.
After checking everything, I noticed that one board was two meters long, but it was not wide enough. Another piece was six meters wide, but it was too short. One support was very high, while the hole under it was two meters deep.
Some of the wooden boards were very thick, but I also needed some thin pieces for the roof. One box was extremely heavy, while another was surprisingly light. The road to the storage area was quite narrow, so I had to be careful when moving the materials.
Unfortunately, one cable was too short, so I had to buy another one. The entire project took roughly three days. The final building was approximately six meters long, and I knew exactly where every part had to go.
By the end of the week, I had finished almost everything. The project took nearly seven days, but now the new storage area is ready to use.